Garland of Joy Necklace Tutorial

By Laura Albu @ Passion4Beadwork

 

this has been a long time coming, but here it is: what to do with the comet element

 

 

Materials

-          6g 11/0 japanese seed beads total

-          60 (about 5g) superduo beads total

-          30 (about 4 g) Czech 2 hole triangles  total

-          36 (about 3g ) Rizo beads total

-           24 Czech Daggers  (I used 12 15x12mm and 12 6x16mm) and 6 2hole Daggers for the center flower

Plus for stringing: 1g 6/0 japanese seed beads; an assortment of 3mm and 4mm pearls or round beads and four 6mm round beads.

-          Beading thread (Toho OneG)

-          Stringing material: flexible beading wire or tigertail.

-          Two crimps (I used four because I’m a nut) and crimp covers if you have them

-          Clasp and extender chain with charm for dangling on the end

 

Adding two little ears to each small flower for stringing:

 

 

 

 

 

 

…and to the large flower

 

Retrace the thread path through these connections to reinforce them.

Decide how long you want your necklace to be. I made mine about 43cm (17in) and also added an extender chain. Measure and cut a length of flexible beading wire or tigertail say 43cm plus  about 12-20cm (5-8in). Begin by stringing the central beads and elements.

 I used the following sequence:

 

• ·         4mm, small flower1 ear1, 4mm, small flower1 ear2,
• 
  
• ·         4mm, 6mm, 4mm,
• 
  
• ·         small flower 2 ear1, 4mm, small flower2 ear2,
• 
  
• ·         4mm, 6mm, 4mm, 11/0, 3mm
• 
  
• ·         Large flower ear1, 4mm, large flower ear2

Repeat in reverse order .

This is what the back of the necklace looks like:

 

 

 

Next string the rest of your beads in whatever order you prefer symmetrically (or not) for the straps.

When you reach your desired length string a crimp (or two). Strimg an 8/0 and ten 11/0s for the end loops (you will use these to attach the clasp). Alternatively you could use horseshoe shaped wire protectors instead of beads for forming the loop. Pass back through the last 8/0 strung, the crimps and next through as many beads as you can manage (I would recommend at least 4-5cm or about 2in). Take care to leave enough wire to repeat this step on the other side. Snug the beads in the loop and collapse the crimps with pliers. If you have crimp covers and a crimp pliers slide those over as well. Repeat on the other side. Attach the two parts of the clasp with jumprings.

That’s it!